How can you clear a clog in a bathroom?

Bathroom clogs are caused by improper use of the sewer, which gets hair, wool and small debris that cannot be kept track of. As a result, all this turns into a lump that does not allow water to pass through. To avoid stagnant water, you should know how and how to clean the blockage in the bathroom. There are several ways, the effectiveness of which will depend on how severe the blockage has formed.

Using a plunger to remove blockages

Surely, this simple device is available in every home. It is used to eliminate blockages in the sink and bath, and in the toilet. It is appropriate to use a plunger not only to eliminate a blockage that has already appeared, but also in order to prevent it.

The more often you use the plunger, the less often a blockage will form.

The instructions for using the plunger are simple, so everyone can use this method:

The plunger must be positioned so that its rubber part completely covers the drain hole.
To make cleaning more effective, it is recommended to pre-fill the bath with some water.
The plunger handle rises a little, then falls, and so on several times. This must be done sharply and continuously, so that the air abruptly enters the sewer and pushes that lump of dirt that does not give a "move" to the water.

Under such pressure, the blockage can go deep into the sewer, and some particles of dirt can float to the surface, they just need to be washed off with water.

Removing clogs with baking soda or vinegar

Despite the fact that today folk methods of removing blockages are not often resorted to, baking soda and vinegar are a universal remedy for blockages that can be used when there are no other remedies for blockages in the bathroom at hand.

There are two options for how to use baking soda and vinegar to break through a blockage:

Pour half a pack of soda into the drain of the bath, in which there should be no water, after 5 minutes, turn on a large pressure of hot water.
Pour four tablespoons of soda into the drain, pour half a glass of vinegar there. Next, the hole must be covered with something to start a chemical reaction. After 10 minutes, you can turn on a strong pressure of hot water.

Attention! Frequent use of this method to clear a blockage can cause pipes to deteriorate. Therefore, it is best to use a plunger for prevention, and in case of blockage - vinegar and soda.

Lemon juice in the fight against blockage

One of the most primitive folk ways to “break through” the sewer is to use ordinary lemon juice. It will take 3-4 whole lemons, from which you need to squeeze the juice directly into the drain and leave it there for two hours (at this time you can not use the bathroom and turn on the water). As soon as two hours have elapsed, a strong pressure of hot water should be turned on.

Sewer cleaners

The easiest way to remove sewer clogs is to purchase special chemicals that do all the work for a person due to their aggressive active ingredients. The most effective will be the one that dissolves hair and wool.

To clear a blockage, any product in the household chemicals department that says it can handle blockages and is suitable for this purpose will do.

To make the right choice among a variety of household chemicals and use it as efficiently as possible, you should use a few recommendations:

Clogging is eliminated not only by products that are sold in powder, but also by liquid products, however, the consumption of liquid products is greater.
In the instructions for the selected product, you should clarify whether it is suitable for your pipes, since not all products are suitable for certain pipes.
The agent itself is poured or poured into the drain hole, but if it is a powder, then it is better to pour another glass of warm water into the pipe on top of it.
When using household chemicals, you should not use the bathroom for a while, as this can lead to the fact that the product simply dissolves in water and does not eliminate the blockage. For each chemical agent, it takes time for the chemical reaction to begin.

Despite the fact that folk methods for resolving the problem that have arisen are quite effective, it is recommended to alternate them with chemicals and be sure to clean the pipes in order to prevent stagnation.

How to clean a blockage in the bathroom: video

In addition to the traditional plunger and chemicals, there are several more effective and not quite standard ways to clean the sewer. You can learn about them from a special video:

A blockage is always easier to prevent than to eliminate, so it is recommended to install a protective mesh on the drain, which will filter dirt and prevent large blockages from entering the pipe. Bath decongestants can be used periodically for cleaning, which will help prevent severe blockages.